Table of Contents
Advertisement
CURSOR WINDOW
Cursor Window ON
CURSOR POSITION
COG TIME LINE
The available Units of Measure for Distance are: Nm, Sm, Km, Nm+Ft, Nm+m. Note when "Nm+Ft"
is selected if the distance is less than 1.0 Nm, it turns to Feet. When "Nm+m" is selected if the
distance is less than 1.0 Nm, it turns to Meters.
3.9
ABOUT PAGE
From Main Menu page it is possible to select the About page containing Software, Chart and
optional devices information.
1
Software System Information
2 Cartography Information
3 Storage Capacity
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight About... and press [ENT] or move the
ShuttlePoint knob to the right.
3. The Information page appears on the screen (see the previous Figure).
4. Press [CLR] or move the ShuttlePoint knob to the left to exit and show the Chart Page.
CP590
By default when the cursor is moved a window is shown with the Lat/Lon Distance and
Bearing from the vessels location to the cursor. This selection allows the window to be
turned On (default) or Off. The Cursor Window is automatically disabled when General
is set in Windows Setup option.
WAAS 3D
The position of the cursor can be customized so it is centered in the middle (if Center
selected) or centered on the bottom of the Chart page (if Bottom selected, default).
It is a line projected from the ship icon which indicates the distance your vessel will travel
at the current speed. Selections are 2, 10 (default), 30 minutes, 1, 2 hours and infinite.
NOTE*
Figure 3.9 - Example of About page
Cursor Window OFF
XXXXXX
YY.YY
INTCHART 1
: WW-M012.03 MARINE FRESHWATER WWBK
BUILT-IN CHARTS: NA-Z010.00
C-CARD 1
: M-NA-M632.00 L. ANGELES and S. PEDRO BAYS
C-CARD 2
: No C-CARD
WAAS 3D
1
2
3
Page 33
Advertisement
Table of Contents
