Data Modul MIO-2261 User Manual page 20

2.2.2.5 VGA/LVDS Interface Connections (CN5 and CN18)
The MIO-2261's VGA interface can drive conventional CRT displays and is capable
of driving a wide range of flat panel displays, including passive LCD and active LCD
displays.The board has two connectors to support these displays: one for standard
CRT VGA monitors and one for LVDS type LCD panels.
CRT display connector (CN5)
The CRT display 15pins connector is a rear I/O connector on coastline used for con-
ventional CRT displays. Resolution: up to 1920 x 1200 (WUXGA).
LVDS LCD panel connector (CN18)
The board supports single channel 18/24-bit LVDS LCD panel displays via 14*1pin
wafer box. Resolution: up to 1366 x 768 (WXGA).
2.2.2.6 mSATA Connector (CN6)
MIO-2260 provides a mini-PCIe socket which integrates USB and SATAII signals,
supports either mSATA or USB interface modules.
2.2.2.7 SATA Connector (CN7)
MIO-2261 features one high performance Serial ATA interfaces. Data transfer rates
up to 300 MB/s enabling very fast data and file transfer, and independent DMA oper-
ation on two ports.
2.2.2.8 Mini PCIe Connector (CN8)
MIO-2261 supports a half size mini PCIe slot. PCI Express Mini Card (also known as
Mini PCI Express, Mini PCIe, and Mini PCI-E) is a replacement for the Mini PCI form
factor based on PCI Express. It is developed by the PCI-SIG. The host device sup-
ports both PCI Express and USB 2.0 connectivity.
2.2.2.9 USB Connectors (CN9 and CN10)
The board provides four USB (Universal Serial Bus) ports, two are rear I/O on coast-
line (CN9); and the other two are internal USB ports (CN10). This gives complete
Plug and Play, and hot attach/detach for up to 127 external devices. The USB inter-
faces comply with USB specification Rev. 2.0 which supports 480 Mbps transfer rate
and are fuse protected.
2.2.2.10 COM Port Connectors (CN11)
MIO-2261 provides 2 x RS-232 serial ports in 10*2pin pin header. It provides connec-
tions for serial devices or a communication network. The pin assignments for the
COM port connector can be found in Appendix.
2.2.2.11 SMBus Connector (CN12)
MIO-2261 provides SMBus connector for customer connection to SMBus protocol
embedded device. It can be configured to I
Advantech also provide SMBus API allowing developers to interface with an embed-
ded system environment and transfer serial messages using the SMBus protocols,
allowing multiple simultaneous device control.
2.2.2.12 Front Panel Connector(CN13)
MIO-2261 integrates below functions as front panel 6pin connector.
Power button
Supports power on/off button in ATX mode.
Reset
If you install a reset switch, it should be an open single pole switch. Momentarily
pressing the switch will activate a reset.
MIO-2261 User Manual
Data Modul AG - www.data-modul.com
2
C by customer's request.
10