Table of Contents
Advertisement
d) Set the digital zoom to ON, to display ZOOM ADJ setting item.
e) The WIDE TELE display of the right side blinks when the cursor is moved to ZOOM ADJ by the
UP or DOWN command and the SET command is transmitted.
f) Under such a condition, the magnification of a digital zoom changes if the UP or DOWN command
is transmitted.
Note
a) Resolution decreases from usual image, when using digital zoom.
b) When digital zoom is used, the light intensity control (LIGHT CONTROL) is fixed to area near
the center of the picture (same as BLC NO.1). In addition, white detection area is also fixed to
area near the center of the picture (same as WB NO.1). Light intensity control and white
detection area of ATW is returned to the previous setting, when digital zoom is set to OFF.
Sub menu (SUB MENU)
a) The OPEN command is transmitted and MAIN MENU is opened.
b) When the cursor [
command is transmitted, SUB MENU is displayed.
◆ ＳＵＢ ＭＥＮＵ ◆
>
ＬＥＮＳ ＴＹＰＥ
：ＤＣ
ＳＹＮＣ ＭＯＤＥ
：ＩＮＴ
Ｈ－ＰＨＡＳＥ
：＋０００
ＣＡＭ－ＲＥＳＥＴ
：ＰＵＳＨ ＳＥＴ
ＲＥＴ
ＥＮＤ
NTSC
Ver : XX . XX . XX
SUB menu
1) Lens Type setting (LENS TYPE)
a) The LENS TYPE display blinks when the cursor [
or DOWN command. Under such a condition, when the SET command is transmitted,
LENS TYPE MENU is displayed
◆ LENS TYPE ＭＥＮＵ ◆
>
ＬＥＮＳ ＴＹＰＥ
ＬＥＮＳ ＯＰＥＮ
ＲＥＴ
ＥＮＤ
LENS TYPE menu
b) The setting cuts as follows when the cursor is matched to LENS TYPE by the UP or DOWN
command, and the SET command is transmitted and it changes.
Set command: DC→VIDEO
] is matched to SUB MENU by the UP or DOWN command and the SET
>
↵
......Lens type setting
......SYNC MODE display
......H-PHASE setting
......Return to camera factry setting
......Return to Main menu
......End(Menu display off）
......Lens type setting
：ＤＣ
......Lens open setting
：ＯＮ
......Return to Main menu
......End(Menu display off）
] is matched to LENS TYPE by the UP
>
44 / 49
Revision A
June 27, 2011
Advertisement
Table of Contents
