Table of Contents
Advertisement
d) It returns to the factory setting (000) when the UP&DOWN command is transmitted.
e) Blinking stops if the SET command is transmitted, the set value is fixed, and the cursor [
moves to AIE.
NOTE: In case of using video signal input type auto iris lens
Lens iris operates by the sensitivity setting of lens regardless light control mode setting.
When the LENS TYPE setting of the camera is set to VIDEO, the lens sensitivity
setting adjustment gauge (Lev/Ref) is displayed on LIGHT CONTROL MENU.
◆
ＬＩＧＨＴ ＣＯＮＴＲＯＬ ＭＥＮＵ
>
ＭＯＤＥ
：ＡＶＥＲＡＧＥ
Ｌ
|||||||||||||||||||||||||||||||||||||||||||||||･･
･････････････････････
Ｒ
||||||||||||||||||||||||||||||||||||||||||||||･･･
････････････････････
ＬＥＶＥＬ
： ０００
ＡＩＥ
：ＯＦＦ
Light control menu [AVERAGE]
Set the sensitivity on the lens such that the Video output level setting [Lev] should not fall
less than the standard level of the exposure control [Ref].
If it is adjusted lower than the value of [Ref], the repetition phenomenon of the lens iris
control and the AGC control (Hunting) might be generated.
3) Back light control mode setting
The lens iris closes in response to brightness when strong light or sun light is hitting the spot
besides the place to be observed, and the subject of interest becomes dark. This mode is used to
avoid darkening of subject of interest in such condition.
a) Use UP or Down commands to move the cursor [
b) It cuts in the following menu display when the SET command is transmitted and BLC is set and
it changes.
◆
ＬＩＧＨＴ ＣＯＮＴＲＯＬ ＭＥＮＵ
>
ＭＯＤＥ
：ＢＬＣ
ＡＲＥＡ ＳＥＬＥＣＴ：ＮＯ．１
ＬＥＶＥＬ
： ０００
ＡＩＥ
ＲＥＴ
ＥＮＤ
Light control menu [BLC]
c) When the cursor [
the detection area select menu that selects the detection area is displayed.
ＡＲＥＡ（ＢＬＣ）
ＮＯ．１
┏━━━━━━┓
┃
┃
┗━━━━━━┛
Detection area setting menu
◆
......Light control mode display
......Video output level gauge
ｅ
ｖ
......Light control standard level gauge
......Video level adjustment(-128～000～+127）
......AIE mode
ｅ
ｆ
......Return to Main menu
......End (Menu display off）
◆
......Light control mode display
↵
......Photomatric Area select : No.1～9
......Video level adjustment(-128～000～+127)
↑
......AIE mode
: ＯFF
......Return to Main menu
......End(Menu display off）
] is matched to AREA SELECT, and the SET command is transmitted,
>
Area position and number
6
┃
┃
2
7
] to MODE.
>
5
4
1
3
8
9
27 / 49
Revision A
June 27, 2011
]
>
Advertisement
Table of Contents
