Table of Contents
Advertisement
5) Error
Error (Word9) of the reply command shows the error of the housing camera.
Table 5.1 shows the content of the error.
Table 5.2 shows the generation factor and measures of the error.
Table 5.1 The content of the error.
Error Code
7 bits
6 bits
5 bits
4 bits
3 bits
2 bits
1 bits
0 bits
Table 5.2 the generation factor and measures of the error.
Content of the
error
The command is
disregarded.
( Notes )
Initial busy
Camera unit
failure
The Specification
date is improper.
Notes
The command disregard is not generated in the command (one that the command title starts by
Call) that reads information.
Content of the error
The command is disregarded.
Initial busy
Camera unit failure
Not used
Not used
Not used
Not used
The Specification date is improper.
Generation factor
When the one shown in the following
was a busy, the transmission
command was transmitted
1) Initial busy
2) Lens busy
3) When camera menu opens
Initial busy
The camera is being initialized.
At the state of the camera unit and
communicate impossible
When the parameter of the
transmitted transmission command
is outside a specified range.
Measures
Please end the operation shown below or
transmit the transmission command after
operation ends.
It waits until initial operation ends.
Please control the zoom and focus by the
Zoom/Focus command.
The parameter is set within the range of
specification.
12 / 49
Revision A
June 27, 2011
Advertisement
Table of Contents
