Table of Contents
Advertisement
d) There are 9 light detection areas that can be selected by the Up or Down command. Select the
areas from No. 1 to 9 such that subject of interest is entered in the selected area.
It is set to No.1 in factory setting.
Up command: 1→2→3→4→5→6→7→8→9
Down button: 9→8→7→6→5→4→3→2→1
e) The setting is fixed when the SET command is transmitted and it returns to LIGHT CONTROL
MENU.
Note
a) The backlighting compensation of a central emphasis is set at the time of electronic
zoom operation.
b) The back light control mode does not operate in case of using video signal input type auto
iris lens.
4) Peak/Average mode setting
When there is strong light spot within the image, the near by area of spot may have overexposure
and the subject might not be confirmed. This mode is used when taking picture under such
condition. It can control overexposure in such conditions.
a) Use UP or Down commands to move the cursor [
b) It cuts in the following menu display when the SET command is transmitted and PEAK/AVE is
set and it changes.
◆
ＬＩＧＨＴ ＣＯＮＴＲＯＬ ＭＥＮＵ
ＭＯＤＥ
：ＰＥＡＫ／ＡＶＥ
>
ＰＫ／ＡＶ
： １５／ ８５
ＬＥＶＥＬ
： ０００
ＡＩＥ
ＲＥＴ
ＥＮＤ
Light control menu [PEAK/AVE]
c) The ratio of peak /average cuts when the cursor [
is transmitted and it changes.
Set command: 0/100→ 15/ 85→ 30/ 70→ 50/ 50→ 75/ 25→ 100/0
The response to spot light increases with increment in peak value. Factory setting is 15/85.
◆
......Light control mode display
......Peak level／Average
......Video level adjustment(-128～000～+127)
↑
......AIE mode
: ＯFF
......Return to Main menu
......End (Menu display off）
] to MODE.
>
] is matched to PK/AV, and the SET command
>
28 / 49
Revision A
June 27, 2011
Advertisement
Table of Contents
