Table of Contents
Advertisement
3) FIX Gain setting (AGC OFF)
a) Use UP or Down commands to move the cursor [
b) It changes into the following display if the SET command is transmitted, and the mode is turned
OFF.
◆
ＡＧＣ ＭＥＮＵ
>
ＭＯＤＥ
：ＯFF
ＦＩＸ ＧＡＩＮ
：＋３１
－６・・・・・・・・●・・・・・・５１
DNR
：OFF
ＲＥＴ
ＥＮＤ
AGC setting menu (OFF)
c) Use UP or Down commands to move the cursor [
b) FIX gain gauge cuts in the blinking when the SET command is transmitted and it changes.
c) Under such a condition, the maximum amplification level is set by the UP or DOWN command.
Fixed amplification level FIX GAIN can be set within the range of -6～+51.
d) Under such a condition, when the SET command is transmitted, a set value is fixed.
The blinking display ends and the cursor [
Note
At high AGC LIMIT/FIX. GAIN, sensitivity increases, but noise becomes more apparent.
4) Digital Noise Reduction (DNR) setting
It is a function to reduce the noise element generated by AGC gain increment.
a) Use UP or Down commands to move the cursor [
b) It changes if the cursor is matched to DNR by the SET command is transmitted.
SET command: OFF → AUTO-LOW → AUTO-MID → AUTO-HIGH
OFF:
DNR is inactive.
AUTO-*
LOW:
Movement priority mode
MID:
Middle mode
HIGH:
Image quality priority mode
DNR is set to AUTO-LOW in factory setting
◆
......AGC mode display
......AGC lmit (－6~+51)
......AGC limit gauge
......Digital Noise Reduction（DNR）display
......Return to Main menu
......End (Menu display off）
>
30 / 49
] to MODE.
>
] to FIX GAIN.
>
] moves to DNR.
] to DNR.
>
Revision A
June 27, 2011
Advertisement
Table of Contents
