Table of Contents
Advertisement
7) Image mirror setting (MIRROR)
Use the Up or Down command to move the cursor [
mirror setting cuts when the SET command is transmitted and it changes.
Set command:
OFF:
Normal picture. (Factory setting)
ON:
Right and left reversing picture.
8) Fog adjustment (FOG ADJUST)
The fog correction function corrects the image that the image has been misted with recording
conditions to a plain image by the picture processing.
When shipping it, it sets it to turning off. The setting changes as follows if the cursor is matched to
FOG ADJUST by the command, and the SET command is transmitted.
Set command: OFF → AUTO (→ MANUAL)
OFF:
Fog adjustment is inactive.
AUTO:
The correction strength is changed automatically with picture conditions. In AUTO
operation, effect is high, when mist is subjected to the whole screen and effect is
low, when mist is subjected to a part of the subject. Fog adjustment is done
automatically.
Note
a) When uniform subject is being captured, correction is done even if there is no mist.
b) There might be noise with this function, depending on the picture shooting conditions.
c) Block noise might be seen due to automatic processing of this function.
9) Digital zoom setting (FOG ADJUST)
a) The setup data display of DIGITAL ZOOM blinks when the cursor [
ZOOM by the UP or DOWN command.
b) Under such a condition, when the SET command is transmitted, DIGITAL ZOOM MENU is
displayed.
◆ DIGITAL ZOOM
MENU ◆
>
M O D E
： O N
ZOOM ADJ ： WIDE TELE
ＲＥＴ
ＥＮＤ
DEGITAL ZOOM menu
c) The mode selection cuts when the SET command is transmitted when the cursor is in the MODE
and it changes.
Set command: OFF→ON
OFF:
Digital zoom is not operated.
ON:
Digital zoom is operated.
OFF→ON
......Digital zoom mode
......Digital
zoom
setting
......Return to Main menu
......End(Menu display off）
] to MIRROR. Under such a condition, the
>
magnification
43 / 49
Revision A
June 27, 2011
] is matched to DIGITAL
>
Advertisement
Table of Contents
