DAF 95XF Maintenance Manual page 118

EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
Inspection and adjustment
6. Fit the central nut (2) to the axle journal
using the socket wrench (6).
7. Place the dial gauge in the dial gauge
holder (3) so that the stylus abuts the hub.
Make sure that the stylus of the dial gauge
does not enter a threaded hole of the hub,
because the stylus might break off when the
wheel is turned.
8. Position the bridge (5) on the extensions (1)
so that the end of the spindle fits into the
recess of the central nut (2). Tighten the
bridge with the nuts.
9. Place a torque wrench on the hexagon
head of the spindle (4).
Press the hub firmly onto the axle journal by
screwing the spindle in, until a tightening
torque of 40 Nm is reached.
5
10. Withdraw the hub by unscrewing the spindle
until a tightening torque of 40 Nm is
reached.
11. Press the hub on to the axle journal by
screwing the spindle in until a tightening
torque of 15 Nm is reached, and set the dial
gauge to "O".
12. Withdraw the hub by unscrewing the spindle
until a tightening torque of 15 Nm is
reached. Take the reading from the dial
gauge and compare this value with the
specified value, see "Technical data".
If the reading falls outside the tolerance
range, the wheel bearing play should be
re-adjusted.
13. Remove the special tool.
14. If the lock nut has been removed, the lock
plate should be replaced. Tighten the lock
nut to the specified tightening torque. See
"Technical data".
3-58
40Nm
(1)
(2)
15Nm
(3)
(4)
95XF series
A800149
40Nm
15Nm
A800150
 200424