DAF 95XF Maintenance Manual page 113

EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
95XF series
9. Place a torque wrench on the hexagon
head of the spindle (4).
Press the hub firmly onto the axle journal by
screwing the spindle in, until a tightening
torque of 40 Nm is reached.
10. Withdraw the hub by unscrewing the spindle
until a tightening torque of 40 Nm is
reached.
11. Press the hub on to the axle journal by
screwing the spindle in until a tightening
torque of 15 Nm is reached, and set the dial
gauge to "O".
12. Withdraw the hub by unscrewing the spindle
until a tightening torque of 15 Nm is
reached. Take the reading from the dial
gauge and compare this value with the
specified value, see "Technical data".
If the reading falls outside the tolerance
range, the wheel bearing play should be
re-adjusted.
13. Remove the special tool.
14. If the lock nut has been removed, the lock
plate should be replaced. Tighten the lock
nut to the specified tightening torque. See
"Technical data".
15. Apply some grease to the outside of the
bearing cage.
16. Apply silicone sealant to the hub cap.
17. Install the spring assembly.
18. Tighten the two wheel nuts to the specified
tightening torque. See "Technical data".
Mark these two nuts and tighten them after
100 km.
 200424
Inspection and adjustment
40Nm
(1)
(2)
15Nm
(3)
(4)
40Nm
15Nm
A800150
5
3-53