IAP-420/420+ User Manual
3.2 Wall Mounting
Besides Din-rail, the device can be fixed to the wall via a wall mount panel, which can be
found in the package.
Wall-Mount Kit Measurement (Unit = mm)
To mount the device onto the wall, follow the steps:
Step 1: Screw the two pieces of wall-mount kits onto both ends of the rear panel of the device.
A total of six screws are required, as shown below.
Step 2: Use the device, with wall mount plates attached, as a guide to mark the correct
locations of the four screws.
Step 3: Insert four screw heads through the large parts of the keyhole-shaped apertures, and
then slide the device downwards. Tighten the four screws for added stability.
ORing Industrial Networking Corp.
8