Usb Interface Model - Star TSP800II SERIES Hardware Manual

10-3. USB Interface Model
ON
OFF
No. 1 2 3 4 5 6 7 8
Switch 1-1
ON
OFF
ON
OFF
The factory settings of DIP switch are all on.
The functions of switches 1-3 through 1-10 will change according to the command emulation
that has been set using switch 1-1 and 1-2.
(1) Star Line Mode
Switch
1-1 Command emulation
1-2 Command emulation
1-3 Should not be changed (Should be set to on)
1-4 Sensor adjustment
1-5 USB mode
1-6 Handshaking conditions
(conditions for BUSY)
1-7 ASB function *1
1-8 NSB function *2
1-9 ~1-10 Should not be changed (Should be set to on)
*1 ASB Function
When this function is enabled, status information is automatically sent to the host whenever the
printer status changes (such as when the cover is opened, paper runs out, or an error occurs).
For information about automatic status information transmission, refer to the separate Program-
mer's Manual (Star Line Mode, Star Page Mode, and ESC/POS Mode).
*2 NSB Function
When this function is enabled, status information is sent automatically whenever the printer
enters into reverse forwarding mode.
For information about automatic status information transmission, refer to the separate Program-
mer's Manual (Star Line Mode and Star Page Mode).
9 10
DIP-SW 1
DIP-SW 1
Switch 1-2
ON
ON
OFF
OFF
Function
Printer class
Vendor class
Printer class
Vendor class
ON
OFF
No. 1 2 3 4
DIP-SW 2
Command emulation
Star Line Mode
Star Page Mode
-
ESC/POS Mode
Always ON
Always ON
Invalid
Printer class
Offline or receive
buffer full
Valid
Invalid
Valid
Invalid
– 42 –
ON
Valid
Vendor class
Receive buffer full
Invalid
Valid
Invalid
Valid
OFF