Getting Started; Figure 1 - Recording With A Dcs 900 / 902 - DCS 900E User Manual

dCS 900E / 902E User Manual
dCS Ltd

Getting Started

Here's what to do:
(If the unit does not behave the first time you power up – contact your dealer, or
dCS.)
do this: Check the appropriate mains supply for your local mains is marked on the
rear panel.
do this: If it is, using the lead supplied, connect the unit to the mains - connect no
other leads at this stage - and switch on.
The unit will test itself for a few seconds while displaying:
Next, the main display will briefly show:
or
and then the sample rate, for example:
do this: Connect a signal source to the analogue inputs.
do this: Connect an output (e.g. from AES1) to your system or a DAC.
do this: Press the
rate you want.
do this: dCS 902 only: Press the
format you want.
From analogue
source
L R
CH1(L) CH2(R) Sensitivity
PUSH PUSH
CH1(L) CH2(R)
AES/EBU
Video
Sync In
Timecode Extension
Set up like this, the dCS 900 / 902 will operate in Master mode, and the system it
is connected to will (have to) lock to it. You should have audio.
Use any output at 32 kS/s or 44.1 kS/s or 48 kS/s.
dCS 902 only: Use any output for double speed data at 88.2 kS/s or 96 kS/s.
Manual part no: DOC0029021E1
Contact on + 44 1799 531 999
dCS
(inside the UK replace + 44 with 0)
All manuals and user guides at all-guides.com
t E S t
- - - - -
- - - - 2
44.1
Sample Rate button (left hand end button) to get the sample
Output Format
Reference In Output A Output B Output C
PUSH
INPUTS
RS-422
DIG1+2 DIG3+4 CH1
Figure 1 – Recording with a dCS 900 / 902
Use (AES1 + AES2) for Dual AES at 88.2 kS/s or 96 kS/s
Page 8
Manual for Software Versions 1.3x to 1.5x
button (right hand end) to get the
Remote
In
CH1 CH2
Out
CLK In CLK Out
Digital recorder
CH2 CH3 CH4
Document No: OS-MA-D0002-902.1E1
email to: more@dcsltd.co.uk
web site: www.dcsltd.co.uk
th
12 June 2000
dCS 900 / 902
MAINS FUSE (2AT) ON OFF