Performing Inspection Measurement - Inspecting Dimension “R”; Setting Head Bevel Gear - Skoda Octavia Workshop Manual

OCTAVIA
Edition 11.99
S00.5130.50.20
Final Drive/Differential
- Remove drive pinion housing together with
shaft bevel gear.
- Install calculated size of shim S
Performing inspection measurement - in-
specting dimension “R”
Insert universal gauge and measure dimension
“R”.
If the correct sized of shims have been selected,
the dial gauge must indicate the figure of the
variation “r” inscribed on the head bevel gear
with a tolerance of + 0.04 mm, when read off in
a clockwise direction (red numerical range).

Setting head bevel gear

Special tools, testers and aids required
♦ End gauge plate MP 3-405/17
♦ Universal dial gauge holder MP 3-447
♦ Pipe section MP 3-462/4
♦ Sleeve MP 3-462/13
♦ Varying measuring lever T30014
♦ Dial gauge
♦ Dial gauge extension 30 mm
It is necessary to re-set the head bevel gear if:
♦ Final drive housing
♦ Cover
♦ Taper roller bearings for head bevel gear/in-
put shaft
or the
♦ Drive pinion set
are replaced.
Overview of settings
.
3
page 39-31
------------ 39-39 -------------
39