01
¡ ¢ £
------------
-------------
¤ ¥ ¦ § ¨ © © ¥
Self-Diagnosis/Electrical Test
! " # $ % & ' "
( ) 0 ) 1 2 3 4 5 ¨ ©
Installation is carried out in the reverse order.
Pay attention to the following points:
K -
Replace O-rings -A- and -B-.
-
Tighten screws to 6 Nm.
-
Inspect oil level in the Haldex coupling
B 4 C 6 D ¥
⇒ page 39-70; change oil in the Haldex cou-
pling if necessary ⇒ page 39-71.
♦ Torque wrench, e.g. V.A.G 1331
♦ Universal tool MP 3-419
-
Switch ignition off.
K -
Unbolt rear propshaft with flexible joint and
vibration damper from rear final drive
(arrows) and carefully push forward ⇒ page
39-44.
K -
Unplug connector for Haldex coupling pump
(arrow 1).
-
Place drip tray below the final drive.
-
Remove screws (arrows 2).
-
After this, turn the pump slightly to the right.
' & '
§
6 6 © ¦ 7
and installing
-
testers and aids
OCTAVIA
8 4 9 @ 8 4 A
Edition 02.00
S00.5130.51.20