Skoda Octavia Workshop Manual page 155

¤ ¥ ¦ § ¨ © ¨    ¦   ¥   ¥ ¦
OCTAVIA
     ! " " ! # $
t testers and aids
♦ Insertion sleeve MP 3-402
♦ Thrust plate MP 3-406
♦ Thrust plate MP 3-407
♦ Assembly device for drive shaft MP 3-422
♦ Thrust plunger MP 3-423
♦ Insertion tool MP 6-428
♦ Thrust plunger MP 3-448
♦ Tube section MP 6-429
♦ Separating device 12...75 mm,
e.g. Kukko 17/1
♦ Pulling device, e.g. Kukko 18/0
♦ Hose strap pliers, e.g. V.A.G 1275
Edition 11.00
S00.5130.52.20
Final Drive/Differential
shaft
%  & '  %  (
Notes:
♦ During manufacture, the entire propeller shaft
is balanced in order to obtain the maximum
possible smooth running. It is not possible ) 0 1 ' ! 2  % 3 " 4 5  6 7 3  8  ! 3 " 4 9
to balance the entire propshaft or the indi-
vidual propshaft tubes with workshop equip-
)
ment. For this reason, if the front or rear
propshaft tube is damaged, it is then always @ !  4  3 !  5  6 7
)
necessary to replace the entire propeller
shaft.
⇒
♦ Do not kink propeller shaft; always store and
transport extended.
) @ % " 1 6  % "  # 7 B 6 6 ' 3 
♦ Before removing, mark the position of all the
parts to each other. Re-install in the same
position otherwise the imbalance will be ex-
cessive and this might result in damage to
the bearings and in rumbling noises.
)
1
 ! 6 
)
60 Nm
 !
C 
)
⇒
3 joint
♦ Removing and installing
D "  1 6 3 " " 6 B " % E F G "  1 6
)
page 39-47
♦ Fitting location
4
♦ When removing and installing, do not 5 # 7  %
)
damage centring sleeve and seal in
middle of flange
5 40 Nm
)
6 Base
7 Collar
♦ Tensioning
8
♦ Knock off with drift before pressing off
CV joint
♦ Inspect for damage
9 Dished
♦ With teeth on inner diameter
♦ Fitting location: large diameter rests
against CV joint
10 Gasket
♦ Replace, pull off protective sheet and
stick into joint
⇒
⇒
heat shield
page 39-48
page 39-46
Fig. 3
¡ ¢ £
------------
39
-------------