Skoda Octavia Workshop Manual page 115

OCTAVIA
4 - Conical bolt, 25 Nm
♦ For output shaft (item 8) or for flange
shaft (item 5), respectively, to the dif-
ferential of the gearbox
5 - Flange shaft
6 - Needle bearing (polygon bearing)
♦ 2 in total
♦ Only for flange shaft (item 5)
♦ Replacing page 39-27
7 - Joint flange
♦ Pull out together with output shaft
(item 8) page 39-3
♦ Pressing off
♦ Pressing on
8 - Output shaft
♦ Pull out of bevel box together with joint
flange (item 7)
♦ Pressing off and pressing on joint
flange page 39-26
9 - Needle bearing (polygon bearing)
♦ Replacing page 39-27
♦ Only for the output shaft
10 - Circlip
♦ Always replace
11 - Seal
♦ Use assembly lever for levering out
♦ Use insertion sleeve MP 3-489 to
knock in as far as the stop
♦ Replace with gearbox installed
ge 39-1
12 - 25 Nm
13 - Cover
1)
♦ Removing page 39-20
♦ Do not twist when installing; tighten
securing bolts in stages diagonally
across
14 - O-ring
♦ Always replace
♦ Must engage in all-round groove
15 - Shim S
1
♦ Note thickness
♦ Setting survey
16 - Large taper roller bearing for head
bevel gear mounting
Inner race:
♦ Pulling off page 39-21
♦ Pressing on
Outer race:
♦ Pressing out
♦ Pressing in
Edition 02.00
S00.5130.51.20
Final Drive/Differential
page 39-26
page 39-26
page 39-3
pa-
page 39-31
1)
page 39-23
page 39-20
page 39-24
17 - Head bevel gear with input shaft
♦ Is matched with the shaft bevel gear
(item 27)
♦ Cannot be pressed off from the input
shaft
♦ Setting page 39-39
18 - Small taper roller bearing for head
bevel gear mounting
Inner race:
♦ Pulling off page 39-21
♦ Pressing on page 39-23
Outer race:
♦ Pressing out page 39-21
♦ Pressing in page 39-23
19 - Shim S
2
♦ Note thickness
♦ Setting survey
20 - Final drive housing
♦ Drain oil, then clamp bevel box in re-
pair stand with gearbox holder
39-17
21 - Seal
♦ Always replace
♦ Insert into final drive housing with
graduated side
22 - O-ring
♦ Always replace
23 - Seal
♦ Always replace
♦ Insert into final drive housing with
graduated side
24 - Oil drain plug, 20 Nm
♦ With magnet
25 - Roller sleeve
♦ Pulling out page 39-22
♦ Pressing in page 39-22
26 - Circlip
♦ Always replace
♦ Removing page 39-22
27 - Shaft bevel gear
1)
♦ Is matched with head bevel gear
♦ Setting page 39-34
28 - Large taper roller bearing for shaft
bevel gear
1)
Inner race:
♦ Pulling off page 39-20
♦ Pressing on page 39-24
Outer race:
♦ Pressing out page 39-19
♦ Pressing in page 39-25
1)
page 39-31
1)
page
------------ 39-15 -------------
39