Skoda Octavia Workshop Manual page 91

OCTAVIA
Edition 11.00
S00.5130.52.20
Shift Mechanism/Housing
K Fitting location of dished washers for secur-
ing bolts
The outer diameter (concave side -arrows-)
points toward 5th gear.
K - Engage 2 gears before tightening the bolts
attaching 5th gear synchroniser body and
sliding gear (arrows) ⇒ page 34-38, Fig.
N34-0927.
- Install 5th gear shift fork.
Setting of 5th gear
K - Engage 5th gear and slacken bolt -1-.
- Push sliding sleeve and shift jaw in direction
of arrow; when doing this, ensure the seg-
ment of the shift jaw is centred in the slot of
the sliding sleeve, and then tighten bolt -1-
to 25 Nm.
l Inspection measurement:
It must not be possible to insert a 0.2 mm
feeler gauge between sliding sleeve and slid-
ing gear. Repeat setting, if necessary.
- Take out 5th gear. Sliding sleeve must now
be in Neutral position. Synchroniser ring must
move freely.
- Install cover for gearbox housing.
- Install complete flange shafts ⇒ page 39-7.
34
------------ 34-47 -------------