Setting Shaft Bevel Gear - Skoda Octavia Workshop Manual

39
------------ 39-34 -------------
Final Drive/Differential

Setting shaft bevel gear

Special tools, testers and aids required
♦ Universal measuring device VW 385
♦ Thrust piece MP 3-420
♦ Pipe section MP 3-450
♦ Thrust piece MP 6-418
♦ Gearbox holder T30012
♦ Stop plate T30012/1A
♦ Commercially available torque gauge
♦ Dial gauge
♦ M 10 hexagon bolt
♦ ∅ 1.5 mm solder wire
It is necessary to re-set the shaft bevel gear if:
♦ Final drive housing
♦ Taper roller bearings for shaft bevel gear
♦ Drive pinion set
or the
♦ Drive pinion housing
are replaced.
Overview of settings ⇒ page 39-31
Determining thickness of shim “S
- Use thrust piece MP 3-420 to press outer
race of the large taper roller bearing for shaft
bevel gear into the drive pinion housing.
- Use thrust piece MP 6-418 to press outer
race of the small taper roller bearing for shaft
bevel gear into the drive pinion housing.
- Use pipe section MP 3-450 to press inner
race of the large taper roller bearing onto the
shaft bevel gear.
K - A - Fit on ∅ 1.5 mm solder wire in place of
the shim S
- B - Fit on spacer ring with chamfer pointing
toward shaft bevel gear.
”
4
.
4
OCTAVIA
Edition 11.99
S00.5130.50.20