Optional Blower
Electrical Supply:
Circulating air blower electrical rating:
115V, 60 Hz, 80 watts. For your protec-
tion against shock hazard, use only a
properly grounded outlet that will ac-
cept a three-pronged plug. Do not cut or
remove the grounding prong.
Consult local codes or, in the absence
of local codes, with the current CSA
C22.1 Canadian Electrical Code and in
the USA with the National Electrical
Code, ANSI/NFPA 70 (latest edition).
Installation:
The burner assembly must be removed
for blower kit installation. Follow
"Burner Removal" section for removal.
Unpack and inspect blower kit.
1) Remove the six screws holding the
fan cover in place at the back of the
firebox.
2) Position the blower assembly over
the two studs located at the rear of
the appliance so that the fan motor is
facing towards the front (Fig. #35).
Do not fasten in place as no fasten-
ers are required.
3) With the speed control knob facing
the front of the unit secure the speed
control assembly with the two #8 x
1/2" sheet metal screws provided
(Fig. #36).
18
Fig. # 34
SNAP DISC
ROCKER
SWITCH
SWITCH
SPEED
CONTROL
Fig. # 35
Fig. # 36
BLOWER
115 VOLTS
60 Hz
0.5 AMPERES
G (green)
L1 (white)
L2 (black)