Surround Assembly - Pacific energy Brentwood Gas Insert Installation And Operating Instructions Manual

Surround Assembly

Warning: Failure to position the parts in accordance with
these diagrams or failure to use only parts specifically
approved with this appliance may result in property
damage or personal injury.
1) Lay Parts A, B, and C face down on a flat, non-marking
surface (Fig. #19). Fasten together with spring clips or 1/
4" x 1/2" bolts through holes at points "D" (Fig. #15).
2) Lift the surround assembly to the upright position and
make sure the front face is even at the joint.
3) Assemble the three trim pieces using the enclosed hard-
ware. Slide Part F into the back corners of the trim and
tighten screws. Ensure the mitred corners fit tightly and
evenly (Fig. # 13).
4) Slide the assembled trim over the surround from the top
(Fig. # 12).
Fig. # 12
Trim
D
Part C
Part A
D
Part B
Fig. # 13
Part F
Trim
5) Tighten the trim retaining screws at the bottom of each
trim side (Fig. # 16).
6) Connect the wire from the spill switch to the on/off rocker
switch in the trim (Fig.# 14).
7) Slide pre-assembled surround on to insert. Do not lift the
assembly by grasping the trim. The surround is held in
place by 2 screws just inside the casing near the top and
bottom. Push surround back until snug and even with front
face of insert. Fasten in place.
Fig. # 15
8) Push the entire appliance back until the surround is in
contact with the fireplace.
Fig. # 16
Fig. # 14
D
Part A
Part C
Trim
Retaining Screw
9