Propane Conversion - Pacific energy Brentwood Gas Insert Installation And Operating Instructions Manual

Propane Conversion

The appliance can be converted to Propane Gas as follows:
Burner Orifice
1) Ensure the burner, pilot and fuel supply are turned off, and
the appliance has cooled.
2) Note log positions and carefully remove them (if in-
stalled).
3) Remove glowing embers and save them for reuse (if
installed).
4) Remove the screws located on the rear corners of the
burner fastening the burner pan in place.
5) Remove the burner by moving it to the right and up. Note
the location of the air shutter adjustment rod and where it
passes through the burner plate and clears the wiring and
plumbing.
6) Using a 1/2" wrench, remove the 27000 Btu orifice,
(marked #332) and replace it with a 25000 Btu orifice,
(marked #145). Apply a small amount of pipe joint com-
pound to the orifice threads to ensure a good seal into the
manifold (Fig. #31).
Pilot Orifice
1) Pull the pilot hood assembly up and off to gain access to
the pilot orifice (Fig. #32 & 33).
2) Remove the orifice with a 5/32" (4 mm) hex key and
replace it with the one supplied with the kit. (Propane
orifice marked #35.)
3) Reinstall the pilot hood assembly.
4) Install the burner pan assembly in the reverse order of
removal, making sure to guide the air shutter adjusting rod
through the hole in the burner plate as the venturi tube is
lowered onto the orifice.
Valve Conversion
1) Open bottom louver to access the control panel.
2) Remove the two screws at the top edge of the control panel
and remove the panel to gain access to gas valve.
3) Follow the installation instructions enclosed with the HI/
LO pressure regulator (820 NOVA HI/LO Conversion
kit) to remove the old regulator and replace with the HI/
LO pressure regulator supplied in the kit.
4) Reassemble the control panel.
Fig. # 31
Burner Orifice
Fig. # 32
Fig. # 33
Pilot
Pilot Hood
Hex Key
17