Louver Installation; Optional Radiant Overlay - Pacific energy Brentwood Gas Insert Installation And Operating Instructions Manual

Louver Installation

Unpack and inspect all parts. A flathead or a #2 Robertson
screwdriver is required to install the louvers.
1) Fasten top louver to the top casing with the screws
provided (see Fig. #22).
2) Fasten bottom louver to the hinge brackets at the bottom
of the appliance (see Fig. #23).
Fig. #22

Optional Radiant Overlay

The optional Radiant Overlay may be installed at any time.
Unpack and inspect all parts. Install Overlay as follows:
1) Remove the glass frame as outlined in "Glass Frame
Removal" section. Place face up on a flat, stable surface to
avoid damage.
2) Remove screws retaining front trim and set trim aside.
3) Position Radiant Overlay over top of frame.
4) Replace trim and screws (Fig. #24).
5) Reinstall complete assembly onto appliance. During in-
stallation ensure that the tabs on the top of the unit engage the
corresponding slots in the glass frame.
Fig. #23
Fig. #24
13