Pacific energy SUMMIT WOOD INSERT DESIGN-A Installation And Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Pacific energy Manuals
  4. Indoor Fireplace
  5. SUMMIT WOOD INSERT DESIGN-A
  6. Installation and operating instructions manual

Pacific energy SUMMIT WOOD INSERT DESIGN-A Installation And Operating Instructions Manual

Hide thumbs Also See for SUMMIT WOOD INSERT DESIGN-A:
Table of Contents

Advertisement

Quick Links

See also: Nstallation and Operating Instructions
IMPORTANT:
THESE INSTRUCTIONS ARE TO
REMAIN WITH THE HOMEOWNER
SAFETY NOTICE
If this stove is not properly installed, a house
fire may result. For your safety, folow the
installation directions. Consult local building
or officials about restrictions and installation
inspection requirements in your area.
TESTED and LISTED
to ULC S628 / UL 1482
Meets the U.S. Environmental Protection
Agency's July 1990 Particulate Emission
Standards
160309-20
Summit
Wood Insert
INSTALLATION
AND OPERATING
INSTRUCTIONS
MODEL
SUMMIT WOOD
INSERT
DESIGN-A
SUMINSERTA
5055.511

Advertisement

Table of Contents
loading

Related Manuals for Pacific energy SUMMIT WOOD INSERT DESIGN-A

Summary of Contents for Pacific energy SUMMIT WOOD INSERT DESIGN-A

  • Page 1 IMPORTANT: THESE INSTRUCTIONS ARE TO REMAIN WITH THE HOMEOWNER Summit Wood Insert SAFETY NOTICE INSTALLATION AND OPERATING If this stove is not properly installed, a house fire may result. For your safety, folow the INSTRUCTIONS installation directions. Consult local building or officials about restrictions and installation inspection requirements in your area.

  • Page 2: Table Of Contents

    Avoiding a Chimney Fire ................. 12 Maintenance ................. 13 Baffle Removal ..................13 Appendix A ................... 14 Troubleshooting ..................14 Firebrick Installation Instructions ............15 Replacement Parts ................... 16 Understanding & Operating Your Pacific Energy Stove ......18 Label ......................19 SUMINSERTA 160309-20...

  • Page 3: Safety

    Safety Clearances READ ALL INSTRUCTIONS BEFORE INSTALLING AND Masonry or Factory Built Fireplace USING THIS APPLIANCE. FAILURE TO FOLLOW IN- STRUCTIONS MAY RESULT IN PROPERTY DAMAGE, The minimum required clearances to surrounding combus- BODILY INJURY, OR EVEN DEATH. tible materials when installed into a masonry or factory built fireplace are listed below and in figure #1.
  • Page 4 Fireplace Hearth (measured without the insert): The non-combustible fireplace hearth must be raised 2" above an adjacent combustible floor and extend 16" in front and 8" beyond each side of the fireplace opening. A non-combustible hearth that extends a minimum 20-1/2" in front of the fireplace opening may be flush to an adjacent combustible floor 16”...

  • Page 5: Installation

    Exception: Masonry or steel, including the damper plate, Pacific Energy highly recommends the use of a full may be removed from the smoke shelf and adjacent damper liner as the safest installation and providing optimum frame if necessary to accommodate a chimney liner, pro- performance.

  • Page 6: Full Flue Liner - (Required In Canada)

    Full Flue Liner - (Required in Direct Flue Connection Fig. # 3 Canada) Mantel or 1) Measure the chimney height from the top of the existing Chimney Top Facing flue to the floor of the hearth. This will allow extra length Flue Liner of liner for flashing and rain cap.

  • Page 7: Surround Assembly And Installation

    Surround Assembly and Installation Fig. # 7 Fig. # 6 1) Lay part A, B and C face down on a flat non-marring surface. Fasten together with 1/4" x 1/2" bolts and nuts provided through holes at points “D” (Fig. #5 and 8). 2) Lift the surround assembly to the upright position and Trim make sure the front face is flat and even at the joints.
  • Page 8 10) Position the decorative bay stove top onto the firebox top. Fig. # 10 Ensure that the studs align with the slotted tabs, one on each side of the firebox top. Secure in place with 1/4” nuts provided. 11) Replace the front panels and ashlip in the reverse order to their removal.

  • Page 9: Combustion Air

    Blower Combustion Air Consult local building codes regarding combustion air sup- ply. Intake or combustion air can be supplied to the Insert The Insert comes equipped with a variable speed circulating in one of two ways: air blower. The blower system is thermostatically controlled 1) Outside air supply: Remove cover from ash clean out for automatic operation, as well manually with a convenient in existing fireplace.

  • Page 10: Operation

    Failure to do so may create a hazard- ous condition. Overnight Burns Your Pacific Energy heater is designed for maximum overall 1) Open door and rake hot embers towards the front of the efficiency at a moderate firing rate. Overfiring is hazardous heater.

  • Page 11: More Wood, More Heat

    Ash Removal 5) To achieve maximum firing rate, set control to "H" (high). Do not use this setting other than for starting or preheat- ing fresh fuel loads. Whenever ashes get 3 to 4 inches deep in your firebox, and when fire has burned down and cooled, remove excess DO NOT OVERFIRE THIS HEATER: Attempts to achieve ashes.

  • Page 12: Creosote

    Creosote Chimney Fires Formation and Need for Removal The result of excessive creosote buildup is a chimney fire. When wood is burned slowly, it produces tar and other Chimney fires are dangerous. Chimney inside temperatures organic vapours, which combine with expelled moisture can exceed 2000 degrees F.

  • Page 13: Maintenance

    WARNING: Only use materials supplied by the manu- facturer when doing maintenance or replacements. Baffle Removal 4. DOOR GASKET - The gasket used by Pacific Energy The Insert and pipe should be removed from the fireplace requires only light pressure to seal. This will prolong seal to clean and inspect.

  • Page 14: Troubleshooting

    Appendix A Troubleshooting Problem Cause Cure Excessive Creosote 1) Wood is too wet - Use dry wood Buildup 2) Turning down air control - Do not turn down until: too soon a) there is a good bed of coals b) the wood is charred 3) Draft too low - Improper chimney height and/or diameter - Chimney plugged or restricted, check flue...

  • Page 15: Firebrick Installation Instructions

    Firebrick Installation Instructions Pacific Summit Wood Stoves (Free-standing and insert models) This package contains 19 full-size firebricks, as well as 5 various cut bricks. If your heater came with an ash cleanout system, or an optional one is being in- stalled, one full-size brick (D) will not be needed for your installation.

  • Page 16: Replacement Parts

    27..Glass Clamp Kit (c/w Screws) ......SUMM.1425 All parts may be ordered from your nearest Pacific 28..Glass Bar Kit (2 pcs.) ........SUMM.312501 Energy dealer. Contact Pacific Energy for the location ..Glass Gasket Kit (not shown) ......DR46.GLKIT of the dealer nearest you.
  • Page 17 Fig. # 18 SUMINSERTA 160309-20...

  • Page 18: Understanding & Operating Your Pacific Energy Stove

    Understanding & Operating Your Pacific Energy Stove The Pacific Energy line of wood stoves is a culmina- Active flaming takes place during the first part of the tion of years of research and development. Designed burn. During this storage, heat is stored in the mass to be efficient, clean-burning and user-friendly, this of the unit and is later released slowly and evenly.

  • Page 19: Label

    ON HEARTH. • OPERATE WITH FEED DOOR CLOSED. OPEN TO FEED FIRE ONLY. • REPLACE GLASS ONLY WITH CERAMIC GLASS. • INSPECT AND CLEAN CHIMNEY FREQUENTLY. UNDER CERTAIN CONDITIONS OF USE, CREOSOTE BUILDUP MAY OCCUR RAPIDLY. CAUTION MANUFACTURED BY: PACIFIC ENERGY FIREPLACE PRODUCTS LTD. PO. BOX 1060, DUNCAN, BC V9L 3Y2 HOT WHILE IN OPERATION. DO NOT TOUCH. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN BURNS. SEE NAMEPLATE AND INSTRUCTIONS. U.S. ENVIRONMENTAL PROTECTION AGENCY DATE OF MANUFACTURE CERTIFIED TO COMPLY WITH JULY, 1990...
  • Page 20 PACIFIC ENERGY FIREPLACE PRODUCTS LTD. Technical Support: 1 887 715-2398 www.pacificenergy.net 2975 Allenby Rd., Duncan, B.C. V9L 6V8 Printed in Canada...

Table of Contents