Glowing Embers; Levelling Legs; Glass Frame Installation - Pacific energy Brentwood Gas Insert Installation And Operating Instructions Manual

Glowing Embers

Note: Use only glowing embers supplied with the
appliance. Use of any other materials or incorrectly
placed embers may cause an incorrect flame pattern,
sooting and/or delayed ignition.
Place 10 to 12 pieces randomly on the front burner area
as shown in figure #20. This will produce the best
results.

Levelling Legs

Levelling legs are provided as a convenient means for
levelling the appliance when it is installed on an irregu-
lar surface. The legs (3" long threaded bolts) are pack-
aged in a separate parts bag inside the appliance. From
the underside, screw the legs into the threaded holes
into the base, near the back of the appliance. Alter-
nately, the burner and fan cover may be removed to
access the weld nuts from inside (Fig. # 18). The legs
thread into the nuts and protrude out the bottom, raising
the rear of the appliance until it is level with the front.
Fig. # 18
Latch
Fig. # 19
12
Frame Tabs
Fig. # 20
Fig. # 21
Weld Nuts

Glass Frame Installation

The glass frame assembly is designed for easy installa-
tion and removal with positioning tabs on top of the
firebox and quick release latches located under the
firebox.
Installation:
1) Grasp the sides of the glass frame assembly and
hook over the frame tabs. Ensure that the tabs on the
top of the unit engage the corresponding slots in the
glass frame.
2) Swing the bottom into position and latch in place
with the over-center latches (Fig. #18).
Removal:
1) Fold down the bottom louver, if installed, to access
the over-center latches. Disengage the latches by
pulling each lever down and forward (Fig. #18).
2) Grasp the sides of the frame and swing the bottom
out to clear. Lift up and then forward to disengage
from top (Fig. #19).
Embers
Fan Cover