Pacific energy NEO 1.6 INSERT-A Installation And Operating Instructions Manual
A series
Hide thumbs
Also See for NEO 1.6 INSERT-A:
- Installation and operating instructions manual (28 pages) ,
- Installation and operating instruction (24 pages) ,
- Nstallation and operating instructions (24 pages)
Table of Contents
Advertisement
Quick Links
IMPORTANT:
THESE INSTRUCTIONS ARE TO REMAIN
WITH THE HOMEOWNER
SAFETY NOTICE
If this stove is not properly installed, a house
fi re may result. For your safety, follow the
installation instructions.
building or fi re officials about restrictions
and installation inspection requirements in
you area.
TESTED and LISTED
to ULC S628 / UL 1482
Meets the U.S. Environmental Protection
Agency's July 1990 Particulate Emission
Standards
220114-20
INSTALLATION
AND OPERATING
Contact local
INSTRUCTIONS
Model:
NEO 1.6 INSERT
Series: A
NEO 1.6 INSERT-A
SERIAL #
5055.750
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Pacific energy NEO 1.6 INSERT-A
Summary of Contents for Pacific energy NEO 1.6 INSERT-A
-
Page 1: Safety Notice
TESTED and LISTED to ULC S628 / UL 1482 Meets the U.S. Environmental Protection Agency's July 1990 Particulate Emission Standards Model: NEO 1.6 INSERT Series: A 220114-20 NEO 1.6 INSERT-A 5055.750... -
Page 2: Table Of Contents
Contact local building or fi re officials about restrictions and installation inspection requirements in you area. Please read this entire manual before you install and use your new room heater. Failure to follow instructions may result in property damage, bodily injury, or even death. NEO 1.6 INSERT-A 220114-20... -
Page 3: Safety
27 9/16" MINIMUM 70” FROM BASE OF Fig. # 1 UNIT TO CEILING Mantel or Top Facing 16” SIDE FACING AND ADJACENT WALL MEASURED FROM EDGE OF DOOR 13 1/2” ” j a c 18” Hearth 220114-20 NEO 1.6 INSERT-A... - Page 4 Consult CAN/CSA-B365 Installation Code for Solid-Fuel-Burning appliances and equipment in Canada, and N.F.P.A. 211 Standard for chimneys, fi replaces, vents and Solid-Fuel-Burning appliances in USA. MINIMUM EMBER PROTECTION DIMENSIONS 16 7/8” USA 18 7/8” CANADA 16” USA Non-combustible hearth 18” CANADA Non-combustible fl oor covering NEO 1.6 INSERT-A 220114-20...
-
Page 5: Creosote Formation And Need For Removal
Chimney fi res are easy to detect; they usually involve one or more of the following: - Flames and sparks shooting out of the top of the chimney - A roaring sound - Vibration of the chimney 220114-20 NEO 1.6 INSERT-A... -
Page 6: Operation
3) After wood has charred, reset air control to desired setting. Your PACIFIC ENERGY heater is designed for many years of trouble free operation. Over fi ring the appliance will shorten 4) When burning at a slow rate for extended periods, the life of the product. -
Page 7: Over Firing
If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders have thoroughly cooled. Other waste should not be placed in this container! 220114-20 NEO 1.6 INSERT-A... -
Page 8: Maintenance
Remove all particles of glass . Be careful as they are very sharp. Install new glass complete with gasket. Replace glass retainers and gasket guides then install new door gasket as per instructions provided with the door gasket kit. NEO 1.6 INSERT-A 220114-20... -
Page 9: Blower Replacement
3. With a 3/8” wrench, loosen the two bolts securing the blower mounting bracket to the unit. Fig. #3 Fig. # 3 7. Reverse all previous steps to reinstall the new blower. Power Cord Position BOLTS 4. Disconnect the two wires leading to the blower motor. 220114-20 NEO 1.6 INSERT-A... -
Page 10: Power Cord Position
4. Engage the power cord in the slot on the left side end of the control assembly. 5. Reconnect the wires to the right side blower and reinstall the control assembly on the unit. Fig. # 6 POWER CORD IN SLOT Fig. # 7 SCREWS STRAIN RELIEF NEO 1.6 INSERT-A 220114-20... -
Page 11: Maintenance Checks
- Replace if the baffle has permanent warping greater than this or has cracking or breakage. - Please contact your Dealer if you experience any of the damage listed above. Continuing to operate your stove with broken parts may accelerate damage to other parts and may void your warranty 220114-20 NEO 1.6 INSERT-A... -
Page 12: Installation
A clean-out door may be required under local codes, collar through the fl ue outlet of the Insert, the baffle must be when a direct fl ue connection is used. Consult local codes. removed (see Baffle Removal section page 8). NEO 1.6 INSERT-A 220114-20... -
Page 13: Direct Flue Connection - (Usa Only)
Insert is removed. b: the chimney damper may be removed to install the liner. 220114-20 NEO 1.6 INSERT-A... -
Page 14: Surround Assembly And Installation
This may involve providing make up air from outside the house. Fig. # 8 SURROUND HOOKS F RO N T S U R RO U N D MOUNTING BRACKET HOLES NEO 1.6 INSERT-A 220114-20... -
Page 15: Blower
CSA C22.1 Canadian Electrical Code and in the USA with the National Electrical Code, ANSI/NFPA 70 (latest edition). Fig. # 9 By-pass Thermo Blowers Rocker Switch Switch Speed Control G (green) L1 (white) L2 (black) 220114-20 NEO 1.6 INSERT-A... -
Page 16: Troubleshooting
1) Combustion air supply - Check outside air supply for obstructions is blocked (see Combustion Air section) 2) Draft too low - Chimney plugged or restricted Inspect and clean - Chimney oversized or otherwise unsuitable Consult Dealer NEO 1.6 INSERT-A 220114-20... -
Page 17: Firebrick Installation Instructions
- Next, install the side fi rebricks, 3 each side. - Lastly, place 4 fi rebricks on the bottom of the heater. ITEM SIZE PART NUMBER 9” X 4 1/2” X 1 1/4” (230 mm x 115 mm x 32 mm) 5096.99 220114-20 NEO 1.6 INSERT-A... -
Page 18: Replacement Parts
17 ..Casing Bottom ..............7846 18 ..Secondary Air Control Assembly ......NE16.7833 19 ..Ashlip ..............NE16.5037701 20..Brick set ............NE16.INSBRIC Parts can be obtained from your local Pacifi c Energy dealer using 21..Flue Collar Handle ..........NE16.78065 these part numbers. NEO 1.6 INSERT-A 220114-20... -
Page 19: Label
MODEL / MODÈLE: NEO 1.6 INSERT SERIES / SÉRIE: A INSTALL AND USE ONLY IN ACCORDANCE WITH PACIFIC ENERGY’S INSTALLATION AND OPERATING INSTRUCTIONS. CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT CODES, RESTRICTIONS AND INSTALLATION INSPECTION IN YOUR AREA. INSTALL AND USE ONLY IN MASONRY OR FACTORY BUILT FIREPLACE. DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE. - Page 20 PACIFIC ENERGY FIREPLACE PRODUCTS LTD. PACIFIC ENERGY FIREPLACE PRODUCTS LTD. Phone: 1-250-748-1184 Phone: 1-250-748-1184 Web site: http://www.pacifi cenergy.net Web site: http://www.pacifi cenergy.net 2975 Allenby Rd., Duncan, B.C. V9L 6V8 2975 Allenby Rd., Duncan, B.C. V9L 6V8 Printed in Canada...
Need help?
Do you have a question about the NEO 1.6 INSERT-A and is the answer not in the manual?
Questions and answers