Log Set
Unpack and inspect log set. There should be a
total of 7 logs. Gas and vent connections should
be made before installing logs. All logs are
numbered on the underside, for their order of
assembly.
Position the logs as indicated by pictures below.
Notches on the underside of logs 2 and 3 are
intended to fit over the andirons. The logs must
butt up against tabs on the burner for proper
positioning and operation (see Fig. #17a).
Note: Improper placement of logs may cause
sooting on internal parts and glass.
Fig. # 17b
Step 1
Rear Log Placement (log #1)
Step 2
Lower Left Log Placement (log #2)
10
Fig. # 17a
Andirons
Fig. # 17c
Step 3
Lower Right Log Placement (log #3)
Step 4
Top Left Log Placement (log #4)
Log Tabs