HP 5800 Series Configuration Manual page 55

Procedure
To configure the device that serves as an SSH server:
Step
1. Enter system view.
2. Create local key pairs.
3. Enable SSH server.
4. Enter one or more VTY user
interface views.
Specify the scheme
5.
authentication mode.
6. Enable the current user
interface to support SSH.
7. Enable command
authorization.
Command Remarks
system-view —
Required.
public-key local create
{ dsa | rsa }
By default, no local key pairs are created.
Required.
ssh server enable
By default, SSH server is disabled.
user-interface vty
first-number —
[ last-number ]
Required.
authentication-mode
By default, authentication mode for VTY user
scheme
interfaces is password.
Optional.
protocol inbound { all
By default, Telnet and SSH protocols are both
| ssh }
supported.
Optional.
•
•
command
authorization
48
By default, command authorization is not
enabled.
By default, command level for a login user
depends on the user privilege level. The user
is authorized the command with the default
level not higher than the user privilege level.
With the command authorization
configured, the command level for a login
user is determined by both the user privilege
level and AAA authorization. If a user
executes a command of the corresponding
command level, the authorization server
checks whether the command is authorized.
If it is, the command can be executed.