HP 5800 Series Configuration Manual page 138

DEACTIVE state
Patches in the DEACTIVE state have been loaded to the memory patch area but have not run in the system
yet. Suppose that the patch file to be loaded has seven patches. After the seven patches successfully pass the
version check and CRC check, they are loaded to the memory patch area and are in the DEACTIVE state. At
this time, the patch states in the system are as shown in
Figure 5 A patch file is loaded to the memory patch area
ACTIVE state
Patches in the ACTIVE state are those that have run temporarily in the system and become DEACTIVE after
system reboot. For the seven patches in
DEACTIVE to ACTIVE. At this time, the patch states in the system are as shown in
The patches that are in the ACTIVE state are in the DEACTIVE state after system reboot.
Figure 6 Patches are activated
Figure
Figure 5, if you activate the first five patches, their states change from
131
5.
Figure 6.