Configuring Http Login - HP 5800 Series Configuration Manual

Hide thumbs Also See for 5800 Series:
Table of Contents

Advertisement

Configuring HTTP login

Step
1.
Enter system view.
2.
Enable the HTTP service.
3.
Configure the HTTP service port
number.
4.
Associate the HTTP service with an
ACL.
5.
Create a local user and enter local
user view.
6.
Configure a password for the local
user.
7.
Specify the command level of the
local user.
8.
Specify the Telnet service type for
the local user.
9.
Exit to system view.
10.
Create a VLAN interface and enter
its view.
11.
Assign an IP address and subnet
mask to the VLAN interface.
Command
system-view
ip http enable
ip http port port-number
ip http acl acl-number
local-user user-name
password { cipher |
simple } password
authorization-attribute
level level
service-type telnet
quit
interface vlan-interface
vlan-interface-id
ip address ip-address
{ mask | mask-length }
65
Remarks
Required.
Enabled by default.
Optional.
80 by default.
If you execute the command multiple
times, the last one takes effect.
Optional.
By default, the HTTP service is not
associated with any ACL.
Associating the HTTP service with an
ACL enables the device to allow only
clients permitted by the ACL to access
the device.
Required.
By default, no local user is configured.
Required.
By default, no password is configured
for the local user.
Required.
No command level is configured for the
local user.
Required.
By default, no service type is configured
for the local user.
Required.
If the VLAN interface already exists, the
command enters its view.
Required.
By default, no IP address is assigned to
the VLAN interface.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5820x seriesA5820x seriesA5800 series

Table of Contents