Oscillator; External Talkback - SoundCraft Si3 User Manual

OSCILLATOR

Route to bus
If this is enabled the Oscillator signal will be routed to any Aux/Group bus which is Soloed whilst the Talkback
ON key is enabled.
Route to all buses
If this is enabled the Oscillator signal will be routed to all Aux/Group buses whilst the Talkback ON key is
enabled.
Level
Set the level of the oscillator signal.
Frequency
Set the frequency of the oscillator signal (Sine only).
Type
Sine or Pink Noise.

EXTERNAL TALKBACK

Route to monitors
Enables the routing of the External Talkback signal from the External Talkback Line Input XLR on the rear-con
to the monitors.
Route to headphones
Enables the routing of the External Talkback signal from the External Talkback Line Input XLR on the rear-con
to the headphones.
Level
Adjusts the gain of the External Talkback input.
Soundcraft® Si3 User Guide Page 6 - 7