Panning & Width Control; Chann; Global Mode; Selecting The Width Control - SoundCraft Si3 User Manual

PANNING & WIDTH CONTROL
As well as normal LR Panning control which is common to all input channels, a Width control is available for
mono inputs when they are routed to LCR.

Chann

The right-hand encoder on an input bay is reserved for Pan regardless of DYN/EQ/BUS1-12/BUS13-24
selection. Press the SEL button on the required input channel.

Global Mode

Select the Global Mode's PAN button. Each encoder on the input bay is now the Pan control for its own
channel.

Selecting The Width Control

Press and hold the Pan encoder wheel until the Pan mode toggles into Width mode. Note that this is only
available for mono inputs which are routed to LCR. The width is variable between 0 and 100%.
To return the encoder to Pan mode, press and hold until it toggles.

FOLLOW OUTPUT SELect BUTTONS

The FOLLOW OUTPUT SELect buttons are used for creating fast sub-mixes to any selected bus output.
Contributions can be made by using the channel faders or the encoders in the VCS.
There are two buttons: ENCODERS (Follow Output Select) and FADERS (Follow Output Select).
When either button is pressed its defined mode will become active. The button will illuminate
white to indicate that its mode is engaged.
If the currently-selected Master Fader Mode does not have a valid FOLLOW OUTPUT SEL mode the
button will illuminate orange to indicate that the button is in 'Primed' mode.
To switch the active mode off press its button again.
Note that there are two sets of these buttons: one for each bank of input channels. They are
independent of each other.

Encoders Follow Output Select

The Input Channels' encoders are used to control contributions from their associated Input Channels to the
selected Output bus.
Note: an Output Channel's SEL button has precedence over an Input Channel's SEL button; therefore
pressing an Input Fader SEL button will NOT place that channel onto the VCS.

Faders Follow Output Select

The Input Channels' Faders are used to control contributions from their associated Input Channels to the
selected Output bus. The input channels' FaderGlow colours will show the colour of the selected output bus.
Note: pressing an Input Fader SEL button will place that channel onto the VCS.
Soundcraft® Si3 User Guide Page 3 - 11