Output Bay - SoundCraft Si3 User Manual

OUTPUT BAY

The output channels' SOLO buttons are used to solo the selected channel. The output Solo is always AFL.
The output Solo is mono unless output busses have been stereo linked in which case the Solo is stereo.
The activated SOLO button will illuminate Blue.
Note: The L, R & C busses cannot be soloed. Individual VCA's cannot be soloed if no inputs have been
assigned to them.
Highlighted AFL
If several outputs are soloed and then one of them is pressed and held, the others will be dimmed by 20dB
(the default value, this can be adjusted via the SOLO touchscreen) and will be illuminated pink. Release the
held solo to revert to standard AFL mode.
Solo Trim
This allows the user to adjust the overall level of the solo bus. The default is 0dB. Adjustment is via the Solo
page of the touchscreen (see Chapter 6).
Blend Level
When a SOLO button is pressed, the soloed signal is routed to the monitor system, at the same time the
monitor system's other signal sources are reduced to the level set by this parameter. The default is minus
infinity. Adjustment is via the Solo page of the touchscreen (see Chapter 6).
Page 5 - 4 Soundcraft® Si3 User Guide