SoundCraft Si3 User Manual page 57

Method 4: Select a group output bus and switch the sends to it from individual input channels as
required.
Proceed as follows:
Using a either the 1-12 or 13-24 button on the Output section, and then the appropriate SEL
button from the output section, select the required output bus.
The input channels' ON button or their associated encoders can be used as the routing controls.
Press ENCODERS (FOLLOW OUTPUT SEL) or FADERS (FOLLOW OUTPUT SEL) on one or both
input bays. Note that as soon as you press these buttons the ENCODERS or ON buttons in the
bay in question will be following whichever output bus happens to be currently selected, i.e. the
ON buttons or push on/push off function of the encoders will not be controlling the input
channels to which they belong, they will now be switching the send from their input channels to
the selected group bus. The FaderGlow element will turn green to confirm this.
Use the INPUT FADERS SELECT buttons A-D as required to access all of the input channels.
To exit this mode press ENCODERS (FOLLOW OUTPUT SEL) or FADERS (FOLLOW OUTPUT SEL)
again to deselect it.
Soundcraft® Si3 User Guide Page 4 - 19