Channel; Tb/Osc; Internal Talkback - SoundCraft Si3 User Manual

CHANNEL

Select the required channel by pressing its SEL button. The channel's name and type (mono or linked) can be
edited/set. When a channel is linked it is automatically linked with an adjacent channel such that the left-
most channel is an odd-numbered one and its right-hand twin is an even-numbered one. The FaderGlow™
bars are illuminated white for linked channels. The Pan controls are not linked.

TB/OSC

Refer to the Monitor block diagram on page 5-2.
There are three sub-pages, accessed by the INTERNAL, OSC and EXTERNAL pads.

INTERNAL TALKBACK

Route To Headphones
Enables the routing of the signal from the Internal Talkback Mic to the headphones.
TB headphone level
Set the level of the signal. See field above.
Route to external
Enables the routing of the Internal Talkback Mic signal from the Internal Talkback Mic to the Talkback Out XLR
on the rear-con.
Talk to bus
If this is enabled the Int TB signal will be routed to any Aux/Group bus which is Soloed whilst the Talkback ON
key is enabled.
Talk to all buses
If this is enabled the Int TB signal will be routed to all Aux/Group buses whilst the Talkback ON key is enabled.
Page 6 - 6 Soundcraft® Si3 User Guide