SoundCraft Si3 User Manual page 34

The following nine Global Mode buttons are available. See also the Global Scroll buttons on the next page.
GAIN
FILTERS/Delay The encoders are used to control the Lo-cut and Hi-cut filters and the time delay
GATE
COMP
EQ
PAN
BUS 1-8, BUS 9-16 and BUS 17-24
Page 3 - 8
The encoders are used to control the Gain of the Input Channels.
of the Input Channels.
The encoders are used to control the Lo-cut and Hi-cut filters in the gate's side
chain, the Threshold, Attack, Gate Hold, Release and Range parameters of the
noise gate.
The encoders are used to control the Threshold, Ratio, Attack, Release, Knee and
Gain parameters of the Compressor.
The encoders are used to control the EQ.
The encoders are used to control the Panning (left-right) of the input channel's
signal to the LCR busses. See the section about Panning, later in this chapter.
These buttons are used as 'jumping in' points to busses 1, 9 and 17 in order to
access the feeds to the 24 aux/group output busses.
Once the required bus has been selected, using these buttons and the Global
Scroll buttons (see next page), the encoders are used to control the level of the
feeds (aux busses only) and whether they are routed or not (press on the
encoder to toggle on/off [aux and group busses]) from their input channels to
the selected output bus.
Note: in the case of aux busses which have been stereo paired, the left hand
one of an encoder pair is used as a send level control, the right hand one is a
balance control. The push-on/push-off functionality is duplicated between both
encoders.
For stereo-paired group busses, the push-on/push-off functionality is duplicated
between both encoders. The balance is controlled by the channel's balance
control.
If the feed to an Aux bus is off, pressing and holding the encoder switches the
feed on and sets the level to unity (0dB). If the feed is on, pressing and holding
the encoder switches the feed off and sets the level to minus infinity.
Soundcraft® Si3 User Guide