Console Overview; Power Supply; Switching On; Switching Off - SoundCraft Si3 User Manual

Hide thumbs Also See for Si3:
Table of Contents

Advertisement

POWER SUPPLY

The console is equipped as standard with one power supply unit. A second PSU may optionally be fitted.

SWITCHING ON

remain illuminated green. The touchscreen will display the progress of the boot-up.
If a second PSU is fitted, and one of them malfunctions, or is switched off, the POWER button will illuminate
red instead of green. This applies only to the steady-state illumination when the console is powered-up.

SWITCHING OFF

Warning. Damage may be caused to the OLED displays on the console if switching off is not
carried out correctly. Do not turn the PSU switch off or disconnect it from the mains supply
until the following procedure has been followed:
Press and hold the illuminated POWER ON button for greater than 1.5 seconds. This will start the power-down
sequence. When the POWER ON button is flashing the mains may be disconnected.
Note: If your console has two PSUs for redundant operation it is permitted to switch one of the supplies off
and disconnect from the mains in order to hot-swap in a replacement PSU.
Note: If for any reason the console software 'freezes', the console may be reset without powering down by
double clicking the Power On button. Audio will continue to be passed during the reset.
LOADING NEW SOFTWARE
Assumimg that the console is off, and that you have the new software on a USB memory device, press and
hold the POWER button for more than 5 seconds.
SUMMARY OF SWITCH ACTIONS
State
Off
Off
On
On
Soundcraft® Si3 User Guide
The POWER ON button on the front of the console is used to turn the console ON
and OFF
When AC mains power is connected to the PSU, and its switch is set to on, the
POWER ON button will slowly flash green (and the blue logos on the sides of the
console will be illuminated).
Pressing the POWER ON button while it is slowly flashing green will activate the
boot-up procedure of the console. The POWER button will then stop flashing and
Action
Short press
Long press, >5s
2 short presses
Long press, > 1.5s

CONSOLE OVERVIEW

Result
Start console
Start console in loader mode
Restart, maintaining audio
Shutdown including audio
Page 2 - 1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents