SoundCraft Si3 User Manual page 9

gases or chemicals.
THIS APPARATUS MUST BE EARTHED. Under no circumstances should the safety earth be disconnected
from the mains lead.
The mains supply disconnect device is the mains plug. It must remain accessible so as to be readily
operable when the apparatus is in use.
Warning. Damage may be caused to the OLED displays on the console if switching off is not
carried out correctly. Do not turn the PSU switch off or disconnect it from the mains supply
until the following procedure has been followed:
Press and hold the illuminated POWER ON button on the front of the console for 4 seconds. This will start
the power-down sequence. When the POWER ON button is flashing green the mains may be disconnected.
See Page 2-1 for more information.
If any part of the mains cord set is damaged, the complete cord set should be replaced. The following information is
for reference only.
The wires in the mains lead are coloured in accordance with the following code:
Earth (Ground):
Neutral:
Live (Hot):
As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the termi-
nals in your plug, proceed as follows:
The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked
with the letter E or by the earth symbol.
The wire which is coloured Blue must be connected to the terminal in the plug which is marked with the letter
N
The wire which is coloured Brown must be connected to the terminal in the plug which is marked with the
letter L
Ensure that these colour codes are followed carefully in the event of the plug being changed
This unit is capable of operating over a range of mains voltages as marked on the rear panel.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipmentis operated in a commercial environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
This Class A digital apparatus meets the requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la Classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du
Canada.
Soundcraft® Si3 User Guide
Green and Yellow (US - Green/Yellow)
Blue (US - White)
Brown (US - Black)
Page 1 - 3