MUTE ALL OUTPUTS BUTTON
OUTPUT FADERS SELECT Button
The Output Faders Select buttons are located to the right-hand side of the output fader bay and are used to
define what functions are assigned to the output faders.
There are four buttons.
1-12
1-12
13-24
13-24
MTX/MAST
MTX/
LRC
VCA
VCA
GEQ
OUTPUT BUS FADERS
The function of these 12 faders is determined by the selection of the Output Faders Select buttons (see
above).
ON BUTTON
The function of the ON button depends upon which Output Faders Select button is active.
Output Fader 1-12, 13-24 and Matrix/Master mode
The output channel ON button is used to switch the selected output channel On or Off. When it is switched
off (unlit), no signal will be routed from the output channel to its designated output.
VCA mode
The output channel ON button is used to switch the selected VCA group master On or Off. When it is switched
off the VCA group is muted and the ON button illuminates Red. When the VCA group master is muted, the ON
buttons on all channel faders assigned to the VCA group will also illuminate Red.
Page 4 - 2
The MUTE ALL OUTPUTS button, which is located just below the Power On button,
applies a 50dB cut to all outputs from the desk. This function is implemented entirely
in hardware, it is not controlled by the console's embedded software. Note that a low
level of audio may still be audible.
This button selects the output faders to be master level controls for bus outputs
1-12.
This button selects the output faders to be master level controls for bus outputs
13-24.
This button selects the output faders to be master level controls for Matrix
Outputs 1-8 and the Left, Right and Centre busses
This button selects the output faders to be master level controls for the VCA
groups 1-12.
Soundcraft® Si3 User Guide