Running The Valueloader System Test; Retrieving Information About The Valueloader; Cycle Count - Quantum ValueLoader User Manual

Running the ValueLoader System Test

Retrieving Information About the ValueLoader

Cycle Count

3
The System Test option cycles the ValueLoader through the process of
loading, calibrating, and unloading all cartridges in the carousel.
Running a System Test verifies the operational soundness of both the
ValueLoader and tape drive. The System Test continues indefinitely until
you press the
[Cancel]
are suspended while a System Test is in progress.
Note: At least one cartridge must be present in the carousel in order
to run System Test.
To run a System Test:
1 From the Home Screen or main menu, press the
appears on the top line of the LCD screen.
Diagnostics
2 When
System Test
to begin the test.
The displays the number of load-unload cycles that have
Test Count
been completed during the test.
3 Press the
[Cancel]
The menu provides access to information about the
Information
ValueLoader, including the cycle count, event log, and firmware revision.
This option displays the total system cycle count, incrementing each time
a tape is loaded into the drive or exported from the ValueLoader.
To use this option:
1 From the Home Screen or main menu, press the
appears on the top line of the LCD screen. Press the
Information
button to access the available options.
ValueLoader LTO-1/LTO-2 Tape Autoloader User Manual
Running the ValueLoader System Test
button. All regular backup and restore operations
appears on the LCD screen, press the
button to end the test.
ValueLoader Administration
or button until
[+] [-]
button
[Enter]
or button until
[+] [-]
[Enter]
3
3
41