Quantum ValueLoader User Manual page 35

An exclamation point (
ValueLoader has identified a cartridge in the indicated slot that is either
an invalid cartridge type or has had a media-related error. These
conditions can be caused by faulty media, possibly due to a corrupt
imbedded servo signal, or dirty read/write heads in the tape drive. The
Media Attention LED is also illuminated in this case (see
on page 23). Exporting the indicated cartridge will clear the error
condition (see Exporting Cartridges
on multiple known good cartridges, consider cleaning the tape drive (see
Cleaning the Tape Drive
conditions repeatedly, that cartridge may be defective or invalid.
Occasionally, you may see the message
• An error condition has caused a cartridge to be left between its slot
and the drive. Power cycle or reset the ValueLoader to clear this
condition.
• A cartridge is unexpectedly found in the Import/Export slot opening.
Power cycle or reset the ValueLoader to clear this condition.
You may also see the message SEQ in the lower-right corner of the
display. this message indicates that the ValueLoader is currently running
in Sequential Mode (see
If the tape drive has a cartridge loaded, the top line displays
The cartridge currently loaded in the drive is indicated by an alternating
black block and the slot number as shown in
also indicate that the specified cartridge is being loaded, unloaded,
imported, or exported as well as indications of read to, write to, and so
on. The ValueLoader status line indicates the current operation. An
example of this display is shown in
ValueLoader LTO-1/LTO-2 Tape Autoloader User Manual
Chapter 2 Operating the ValueLoader
) displayed in the inventory indicates that the
!
on page 28). If these symptoms occur
on page 31). If a particular cartridge causes error
In Transit
ValueLoader Operating Modes
figure 10.
Operator's Panel Overview
LED Indicators
, which may indicate:
on page 38).
Drive loaded
figure 10. This display can
.
21