Quantum ValueLoader User Manual page 53

Circular Mode On/Off
used only when in Sequential Mode. When Circular Mode is on, after the
ValueLoader has cycled through all available cartridges, it then reloads
the original first cartridge in the sequence. If Circular Mode is turned off
and the last cartridge has been unloaded, the ValueLoader stops loading
cartridges until you manually load another cartridge.
Caution: Use caution when choosing Circular Mode as it makes it
possible to overwrite data on previously written
cartridges.
To access this option, follow these steps:
1 From the Home Screen or main menu, press the
appears on the top line of the LCD screen, and then press
Configuration
the button to select.
[Enter]
2 Press the or
[+] [-]
screen. The second line on the LCD screen indicates the current status
of this mode, either
3 Press to select. The LCD screen indicates whether you are
[Enter]
about to turn Circular Mode on or off.
4 Press the
[Enter]
press to exit and not save the changes.
[Cancel]
Autoload Mode On/Off
only used when in Sequential Mode. When Autoload Mode is on, the
ValueLoader automatically loads the cartridge from the lowest numbered
full slot into the tape drive when powered on. It then follows standard
sequential operation as described in
To access this option, follow these steps:
1 From the Home Screen or main menu, press the
appears on the top line of the LCD screen, and then press
Configuration
the button to select.
[Enter]
2 Press the or
[+] [-]
screen. The second line on the LCD screed displays the current status,
either or .
On Off
ValueLoader LTO-1/LTO-2 Tape Autoloader User Manual
. This option turns Circular Mode on or off, and is
button until
Circular Mode
or .
On Off
button to accept the change to Circular Mode or
. This option turns Autoload Mode on or off, and is
Sequential Mode
button until
Autoload Mode
ValueLoader Administration
Configuring the ValueLoader
or button until
[+] [-]
appears on the LCD
on page 38.
or button until
[+] [-]
appears on the LCD
39