Quantum ValueLoader User Manual page 51

To access this option, follow these steps:
1 From the Home Screen or main menu, press the
appears on the top line of the LCD screen, and then press
Configuration
the button to select.
[Enter]
2 Press the or
[+] [-]
screen, and then press
3 Press the or
[+] [-]
or .
Loader Drive
4 Press the
[Enter]
Change Loader ID
selected. The second line displays
current SCSI ID for that device.
5 Press the or
[+] [-]
6 Press the
[Enter]
indicates
Please Cycle Power
other device, go back to
7 Once both SCSI IDs are set correctly and the
message is displayed, turn off the ValueLoader. After a few seconds,
turn it back on again.
The selected SCSI ID is now in effect.
Note: If you changed the SCSI ID, you may also need to reboot the
host server and reconfigure your backup software before you
can use the ValueLoader. Consult your hardware and software
manuals for more information.
ValueLoader LTO-1/LTO-2 Tape Autoloader User Manual
button until
Change SCSI ID
to select.
[Enter]
button until the desired device is displayed, either
button to select. The LCD will then display either
or depending on which device was
Change Drive ID
New SCSI ID: xx
button until the desired SCSI ID is displayed.
button to select the new ID number. The LCD screen
. If you need to change the SCSI ID for the
step 4.
ValueLoader Administration
Configuring the ValueLoader
or button until
[+] [-]
appears on the LCD
where is the
xx
Please Cycle Power
37