Resetting The Valueloader; Changing The Scsi Id - Quantum ValueLoader User Manual

Quantum valueloader lto-1/lto-2 tape autoloader
Hide thumbs Also See for ValueLoader:
Table of Contents

Advertisement

ValueLoader Administration
Configuring the ValueLoader
Resetting the
ValueLoader
3
Changing the
SCSI ID
3
36
To access the
Configuration
press the
or
button until
[+]
[-]
LCD screen. Press the
available options. Press the
option.
This option resets the ValueLoader robotics and the tape drive within the
ValueLoader, forces a new cartridge inventory, and clears any current
error condition.
This option is primarily used if the ValueLoader is in an error
Note:
state.
To access this option, follow these steps:
1 From the Home Screen or main menu, press the
appears on the top line of the LCD screen, and then press
Configuration
the
button to select.
[Enter]
2 Press the
or
[+]
[-]
3 Press
to reset the ValueLoader.
[Enter]
After initialization, the ValueLoader returns to normal operation and
displays the Home screen.
This option changes the SCSI ID of the ValueLoader and/or tape drive.
The ValueLoader occupies two SCSI IDs (target addresses), one for the
tape drive and the other for the ValueLoader robotics.
The default SCSI IDs for the ValueLoader are
for the robotics. You should only need to change the SCSI IDs if there are
other devices on the SCSI bus using the same SCSI ID.
ValueLoader LTO-1/LTO-2 Tape Autoloader User Manual
menu from the Home Screen or main menu,
appears on the top line of the
Configuration
button and then
[Enter]
button to execute the displayed menu
[Enter]
button until
appears on the LCD screen.
Reset
or
to access the
[+]
[-]
or
button until
[+]
[-]
for the tape drive and
6
5

Advertisement

Table of Contents
loading

Table of Contents