Deleting A Remote Control - Rosslare HLX-40 User Manual

User Menu Options
To enroll a remote control and specify a function:
1. Using the Menu button, select Remote Controls and press
Enter.
2. Select the desired remote control number 01-08 by either
browsing the remotes using the Menu button or by entering
the remote number using the numeric keypad.
3. Enroll the remote control when the "WAITING FOR SIGNAL"
message is displayed by pressing a button on the remote
you wish to enroll.
4. When the signal is detected, you are asked to press the
Enter button to store and save your selection.
5. Once the selection is stored, you can then choose to
configure each of the remote control buttons to behave in
one of the following options:
Restore Default (reset to its original functionality)
•
Operate PGM 1
•
Operate PGM 2
•
Status Request
•
6. At any time, you can press the ESC button to exit the
menu.
Note:
Once you exit the menu (after saving the enrollment)
you cannot change the button's behavior, unless you
delete the remote and re-enroll it.

9.9 Deleting a Remote Control

To delete a remote control:
1. Using the Menu button, select Remote Controls and press
Enter.
2. Select the pre-enrolled remote control number 01-08 by
either browsing the remotes using the Menu button or by
entering the remote number using the numeric keypad.
You are asked to confirm deletion.
3. Press Enter to delete the remote control or the ESC button
to go back.
Page 32 HomeLogiX HLX-40 User Guide