Quick Arming; Instant Arming; Forced Arming; Entry/Exit Delay Options - Rosslare HLX-40 User Manual

Operating the HLX-40
2.3.4.

Quick Arming

Quick arming allows arming the system without code entry. If
Quick Arming is enabled (by the Installer during setup), a long
press on one of the arming buttons activates Quick Arming.
2.3.5.

Instant Arming

If Instant Arming mode is enabled (by the Installer during
configuration), the system skips the exit delay, cancels the
entry delay configured, and initiates the alarm, which instantly
causes an alarm to go off upon violation of any zone.
Note:
When EN-CENELEC standard is enabled, only the Master
user can use this feature.
To instantly arm the system:
1. Verify that the system is ready for arming.
2. Press either the HOME or the AWAY arming key.
3. Enter your user code.
4. Press the same arming key once again. (If EN-CENELEC
standard is enabled, enter your Master user code once
again).
2.3.6.

Forced Arming

If Forced Arming is enabled, the system is able to arm even
when zones are in violation (open) but not defined as
bypassed. In such a case, the system arms, effectively
bypassing the open zone. Once the open zone is closed, the
system completes arming, adding the previously bypassed
zone to the monitored zones.

2.4 Entry/Exit Delay Options

Entry and Exit actions delay the alarm mode and allow the
system to ignore zone violations, as described below.
Page 10 HomeLogiX HLX-40 User Guide