Sms Commands - Rosslare HLX-40 User Manual

8. SMS Commands

The HLX-40 family supports remotely controlling the system
using a cellular phone by accepting SMS commands from the
user's cell phone to the GSM's SIM card provided that the MD-
CC101 GSM Stick expansion is installed and functioning
properly.
To perform cellular remote commands:
1. Send an SMS command according to the table below
along with either the Master code or one of 20 enabled
user codes.
The format of the message is the command as listed
below, space, followed by the master or user code.
For example: "Arm Away 1234"
Message
Arm Away
Arm Home
Disarm
Activate PGM1
Deactivate PGM1
Activate PGM2
Deactivate PGM2
HomeLogiX HLX-40 User Guide
To
Arm the system in Away mode. This mode
arms all sensors and detectors. Use this
function when there is no one in the
home/office.
Arm the system in Home mode. This mode
arms all perimeter sensors and detectors as
defined by the installer. Use this function
when the home/office is occupied.
Disarm all armed sensors and detectors.
If the duress code is enabled by the Installer,
entering the duress code when disarming
sends a duress event to the Central Station
and to a private phone.
Activate a predefined PGM designated by
the installer PGM1
Deactivate a predefined PGM designated by
the installer PGM1
Activate a predefined PGM designated by
the installer PGM2
Deactivate a predefined PGM designated by
the installer PGM2
SMS Commands
Page 27