Enrolling A Remote Control; Deleting A Remote Control - Rosslare HomeLogiX HLX-40 User Manual

User Menu Options
9.8

Enrolling a Remote Control

You can enroll up to eight remote controls, and specify functions for each
button on the remote control. You can also delete enrolled remote controls.
To enroll a remote control and specify a function:
1. Using the Menu button, select Remote Controls and press Enter.
2. Select the desired remote control number 01–08 by either browsing the
remotes using the Menu button or by entering the remote number using
the numeric keypad.
3. Enroll the remote control when the "
displayed by pressing a button on the remote you wish to enroll.
4. When the signal is detected, you are asked to press the Enter button to
store and save your selection.
5. Once the selection is stored, you can then choose to configure each of the
remote control buttons to behave in one of the following options:
Restore Default (reset to its original functionality)

 Operate PGM 1
Operate PGM 2

 Status Request
6. At any time, you can press the ESC button to exit the menu.
Once you exit the menu (after saving the enrollment) you cannot change the
button's behavior, unless you delete the remote and re-enroll it.
9.9

Deleting a Remote Control

To delete a remote control:
1. Using the Menu button, select Remote Controls and press Enter.
2. Select the pre-enrolled remote control number 01–08 by either browsing
the remotes using the Menu button or by entering the remote number
using the numeric keypad.
You are asked to confirm deletion.
Press Enter to delete the remote control or the ESC button to go back.
3.
32
WAITING FOR SIGNAL"
HLX-40 User Manual
message is