Netlinx; Ping; Reboot - AMX Modero G5 Instruction Manual

SSH Commands
SSH Commands (Cont.)
msg (cont.)

netlinx

ping

reboot

120
--on, -N, --enable, --start
Enable diagnostics message output.
--remove-filter, -rf
Remove one or more filters form the current diagnostics log filter.
--show-filter, -sf
Display all existing filters applied to diagnostics logging.
--verbose, -v
Display verbose diagnostics message status information.
Gets/sets the NetLinx ICSP connection settings. An interactive menu is available when using the set
proxy (i.e. "set netlinx").
Syntax:
*:netlinx [options]
Options:
--clear-credentials, -cc
Clear the username and password settings.
--config, -c, --set
Set NetLinx (ICSP) connection settings.
--device, -d
Set the device number.
--help
Display this help message.
--info, -?
Display the current NetLinx settings.
--mode, -m
Set the connection mode (AUTO, URL, LISTEN).
--password, -pw
Set the password for secure mode.
--reset, -r
Reset NetLinx settings to factory default.
--system, -s
Set the system number.
--url, -u
Set the URL of the master controller.
--username, -un
Set the username for secure mode.
Test TCP/IP network connectivity with another IP address.
Syntax:
*:ping [options] address
Arguments:
address
IP Address or URL.
Options:
--help
Display this help message.
--retry-count, -c
Retry Count (number of packets).
--timeout, -w
Reboot the device.
Syntax:
*:reboot [options]
Options:
--help
Display this help message.
--silent, -s, -Y
Do not prompt for confirmation; proceed with reboot.
Modero G5 Touch Panels - Configuration and Programming