Slt - AMX Modero G5 Instruction Manual

Panel Commands (Cont.)

^SLT

Modero G5 Touch Panels - Configuration and Programming
Video Slot Command (aka MultiPreview Command)
Syntax:
"'^SLT-<device>,<subcommand>'"
Variables:
device = 1 (Device is always 1 for the MXA-MP and MXA-MPL, the only device type currently supported
by Modero X Series panels)
Subcommands = reboot, start, stop, videomode, audiovideoenable, videoinput
^SLT-1,reboot=<current(default),previous,factory>
Slot command to reboot the MXA-MP or MXA-MPL. If previous or factory is specified, the MXA-MP/
L will revert its firmware to either the previously loaded version or the factory installed version,
respectively.
"'^SLT-1,start=<audio,video,both>'"
MXA-MPL Start stream - Tells the Breakout Box to start streaming audio, video or both.
"'^SLT-1,stop'"
MXA-MPL Stop stream - Tells the MXA-MPL to stop streaming.
"'^SLT-1,videomode=<format>,<resolution>'"
Note: When using HDMI sources, use the DIGITAL source, but with DVI and other formats, use the
ANALOG source. Set format, resolution and rate for MXA-MPL
video format = <hdmi|dvi>
Resolution = <horizontal>x<vertical><i|p>@<rate>
"'^SLT-1,audiovideoenable=<video(default)|audio|both>'"
MXA-MPL Video enable command - Sets the option to enable video on subsequent streams from the
MXA-MPL.
Note: This does not work immediately; it will take effect on the next Stream start. It can still be
overridden in the "^SLT-1,start" command.
"'^SLT-1,videoinput=<on|off>'"
Turn on/off the video input to the MXA-MP/MPL.
Examples:
SEND_COMMAND Panel, "'^SLT-1,start=both'"
Start both the audio and video streams.
SEND_COMMAND Panel, "'^SLT-1,stop'"
Stop the current stream.
Programming - Send Commands
61